Workshop Manuals Factory service & repair Aston Martin
01 00 Introduction02 01 Body system03 02 Frame and mounting04 03 Engine05 04 Suspension06 05 Driveline07 06 Brake system08 07 Transmission09 08 Clutch10 09 Exhaust11 10 Fuel12 11 Steering13 12 Climate control14 13 Information, gauge and warning15 14 Power supply16 15 Vehicle entertainment17 16 Vacuum distribution18 17 Lighting19 18 Electric distribution and electronic control20 19 Electronic features21 20 Appendix and glossary22 Circuit diagrams23 Squeaks and rattles repair manual24 Bluetooth system (training guide)25 On board diagnostics (EOBD)26 Service bulletins
Aston Martin V8 Vantage Factory Workshop Manual (2005-2010)01 · 00 Introduction
01 · General

General

Make
Aston Martin
Model
V8 Vantage Factory Workshop Manual
Year
2005–2010
Section
Vehicle Recovery › General
00 IntroductionGeneral

General

Preferred method of vehicle recovery is by flat bed transporter.

The towing eye is primarily for emergency use when towing for short distances, e.g. removing vehicle if it is causing an obstruction or winching vehicle onto a flatbed transporter. If moving this vehicle in such a situation, install the towing eye to the bracket in the lower grille aperture.

WARNING WHEN THE ENGINE IS NOT RUNNING, THE STEERING WILL NO LONGER BE POWER-ASSISTED AND THE BRAKE BOOSTER WILL BECOME INEFFECTIVE AFTER A FEW APPLICATIONS OF THE BRAKES. BE PREPARED FOR RELATIVELY HEAVY STEERING AND THE NEED FOR GREATLY INCREASED BRAKE PEDAL PRESSURE.

Take care to protect the paint work when installing the towing eye. Ensure the towing eye is tight.

Transporting

If vehicle is to be transported on a trailer or flat bed transporter the handbrake must be applied and the road wheels must be chocked.

Suspended Towing

Do not tow with ‘sling’ type equipment as this could result in damage to the bodywork.

Take care when using ‘spectacle frame’ type towing equipment that the towing device is well clear of front or rear apron. Body damage may occur if vehicle passes over uneven road surfaces.

Front Suspended Tow

  1. Remove the ignition key from the ignition.
  2. Raise the vehicle using a ‘spectacle frame’ type lifting device with a cradle positioned under each front wheel as indicated below.
Front suspended tow diagram showing a tow truck lifting a car with cradles under the front wheels.

Rear Suspended Tow

  1. Set the steering in the ‘straight ahead’ position. Remove the ignition key from the ignition. Ensure the steering is locked in the straight ahead position.
  2. Raise the vehicle using a ‘spectacle frame’ style lifting device where a cradle is positioned under each rear wheel as indicated below.
Rear suspended tow diagram showing a tow truck lifting a car with cradles under the rear wheels.

Adhere to Towing Regulations

In certain countries the registration number of towing vehicle and an ‘ON TOW’ sign or warning triangle must be displayed in a prominent position at the rear of vehicle being towed.

Towing by Another Vehicle

This vehicle may be towed short distances by another vehicle provided that a speed of 48 km/h (30 mph) is not exceeded. Ensure the towed vehicle gear selection is in ‘Neutral’ with ignition key turned to position ‘II’ to release steering lock and to render horn, indicators and brake lights operational.

Parts & tools for this job For 2005 Aston Martin V8 Vantage

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.