audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removing and installing front trim panel for sliding/tilting sunroof > < Removing and installing sunroof motor
Adaption for motor
Adaption for motor
  Note
t  If you have renewed a motor or if the battery has been disconnected, the motor must be adapted.
t  Proceed as follows:
–  Switch on the ignition; doors must be closed.
   
–  Pull the switch to operate the motor -1- downwards and keep holding it in this position during the entire adaption process.
–  After approx. 10 seconds, the glass panel should tilt, then open completely, run to the front and close again.
–  Once the panel has closed, the adaption process is completed and you can release the operating switch.
  Note
Alternatively you can also use the → Vehicle diagnostic tester to perform the adaption.
  A60-10384

Removing and installing front trim panel for sliding/tilting sunroof > < Removing and installing sunroof motor