A2
| Exploded view - removing and installing input shaft, output shaft, differential and selector forks |
| 1 - | Differential |
| q | Dismantling and assembling → Chapter |
| 2 - | O-ring |
| q | 4x |
| q | Always renew |
| 3 - | Output shaft |
| q | Dismantling and assembling → Chapter |
| 4 - | Reverse shaft support |
| q | Dismantling and assembling → Item |
| 5 - | Reverse shaft |
| q | Dismantling and assembling → Chapter |
| 6 - | Input shaft |
| q | Dismantling and assembling → Chapter |
| 7 - | Reverse gear selector fork |
| q | Dismantling and assembling → Chapter |
| q | Installation position → Anchor |
| 8 - | Torx socket head bolt |
| q | 25 Nm |
| 9 - | Selector mechanism |
| q | (Selector forks) |
| q | Dismantling and assembling → Chapter |
| 10 - | Clutch housing |
| q | Servicing → Chapter |
| 11 - | Hexagon nut |
| q | 25 Nm and turn 90° further |
| q | 4 nuts for bearing mounting |
| 12 - | Flange shaft with spring |
| q | Removing and installing → Chapter |
| q | Assembling → Item |
| 13 - | Countersunk bolt |
| q | 25 Nm |
