A2
Exploded view - selector mechanism |
1 - | O-ring |
q | Renew |
2 - | Potentiometer for selector lever forward and backward -G272- |
q | Can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
q | Removing and installing → Chapter |
3 - | Bolt |
4 - | Push rod |
q | Removing and installing → Chapter |
5 - | Spring |
q | Removing and installing → Chapter „Removing and installing selector lever pushrod“ |
6 - | Cover |
7 - | Clamp |
8 - | Detent |
q | Removing and installing → Chapter |
9 - | Pin |
10 - | Bolt |
q | 5 Nm |
11 - | Securing clip |
q | Secures bearing bush -item 12- in position in mounting plate -item 13- |
q | Installation position: Angled end points towards selector lever |
12 - | Bearing bush |
13 - | Base plate |
14 - | Wiring harness |
q | With selector lever gate detector switch -F257-, selector lever detector switch for N -F258-, selector lever detector switch for stopped -F259-, selector lever detector switch for E -F271- |
q | Can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
15 - | Cable clip |
16 - | Bolt |
q | 10 Nm |
17 - | Selector housing |
18 - | Spring |
19 - | Selector lever lock solenoid -N110- |
q | Can be tested in the Electrical checks and in the measured values → Rep. gr.01 |
q | Removing and installing → Chapter |
20 - | Bracket |
q | For supporting roller -Item 21- |
q | Installation position: Roller mount faces along selector housing |
21 - | Roller |
q | Grease sliding surfaces |
22 - | Washer |
23 - | Bolt |
24 - | Locking lever |
q | Inserted in mounting plate and connected to selector lever lock solenoid -N110- |
25 - | Retaining clip |
q | Removing → Anchor |
q | Installing → Anchor |
26 - | Bearing bush |
27 - | Selector lever |
q | Removing and installing → Chapter |