audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Erasing fault memory > < If faults occur during basic setting

A2

Programming the creep point
Programming the creep point
Requirements
l  Engine is at operating temperature.
l  Selector lever in position “STOP”.
Procedure
–  Apply handbrake fully.
–  Start engine.
–  Connect the vehicle diagnostic, testing and information system -VAS 5051 A- → Chapter and select the vehicle system “02 - Gearbox electronics”.
   
Display on -VAS 5051 A-:
–  From list -1- select diagnostic function “08 - Read measured value block”.
  A01-0122
Display on -VAS 5051 A-:
1 - Enter display group (max. input value = 255)
–  Use keypad -2- to enter “25” for “Display group 025” and confirm by touching Q key.
  A01-0130
Display on -VAS 5051 A-:
–  In the display zone -3- check the value for the programming of the creep point.
l  Specified value: 0
  Note
If the value e.g. is at “4”, the creep point must be programmed at least another 4 times.
–  To do this, shift selector lever to position “D”.
–  Press the brake pedal and hold it down for at least 3 seconds.
–  Release the brake pedal for at least 3 seconds.
–  Repeat this process until the value in display zone -3- is at “0”.
When the value is at “0”, the creep point is adjusted correctly.
–  End diagnostic function “08 - Read measured value block” by touching ← key.
  A01-0187
–  From list -1- select diagnostic function “06 - End output”.
Display on -VAS 5051 A-:
If the value “0” has not been reached after programming the creep point several times, the fault memory of the engine control unit must be interrogated.
  A01-0122

Erasing fault memory > < If faults occur during basic setting