A3 L4-2.0L Turbo (BPY) (2006)
![background image](/audi/a3/l4-2.0l_turbo_(bpy)/Page-4473003.png)
Note:
^
Sensor wire in steering gear housing is equipped with a locking mechanism - arrow -for spiral spring. Make sure that spiral spring is not
twisted when removing sensor wire.
-
Disconnect harness connector of sensor wire at steering pinion.
Press terminal off spiral spring housing, using screwdriver (blade width 3 mm), as shown in illustration.
-
Mark position of steering pinion to steering gear housing.
-
Pull out steering pinion with steering torque sensor out of steering gear housing. Secure spiral spring to avoid turning, using adhesive tape or
similar.
Installing