A3 L4-2.0L Turbo (BPY) (2006)
/Page-4473004.png)
-
Coat bearing - arrow - and splines of steering pinion with G 052 192 A1.
Do no apply grease on or near sensor!
New steering pinion with steering torque sensor is equipped with a securing element - arrow -. It must not be pulled out before sensor wire was
secured.
-
Insert steering pinion into steering gear housing.
-
Turn steering pinion until spiral spring with sensor wire can be locked - arrow -.
Marking made on removal must align with marking on steering gear housing.
-
Pull securing element out of spiral spring.
-
Insert terminal into spiral spring housing.
Terminal is coded and fits only in one direction.
-
Tighten steering pinion using new hex nut.
Rack moves until stop.
-
Apply sealant LOCTITE 5910 on thread of locking bolt.
-
Install locking bolt, filled with grease G 052 192 A1 and tighten.
-
Turn steering to straight-ahead position again.