Audi Workshop Service and Repair Manuals

• Panel
• ◆ Remove => Fig3.
• Shim plate
• Lock cylinder
• ◆ Door sub-frame removed.
• ◆ Before removing unclip securing rod -10-.
• ◆ To remove, swivel rotary clip -4- to the rear (away from direction of travel) and remove lock cylinder.
• Rotary clip
• Door handle
• ◆ Unclip cover -7-.
• ◆ To remove, detach rotary clip -4- and unscrew bolt -6-.
• Combi bolt
• ◆ 5 Nm

• Door lock cover
• ◆ To remove, first unclip cover at top, then pull out of door lock at bottom.
• Securing rod
• ◆ To remove, unclip at safety piece -9-.
• Operating clip
• ◆ Installing => Fig1.
• Lock cylinder securing rod
• ◆ Installing =>Fig.1.

Fig. 1    → Installing securing rod for locking cylinder

• ‒ Clip collar -2- into release lever -1-.
• ‒ Insert securing rod -3- for locking cylinder into collar -2- and clip in.
• ‒ Insert securing rod -3- for locking cylinder into operating clip -4- and clip in.
• ‒ Take care not to strain locking lever -5- at door lock (max. play at locking lever 1 mm =>Fig. 2).
• ‒ Push sleeve on operating clip -4- upwards.

Fig.2    → Adjusting play for locking lever

• ‒ Enter securing rod -1- in operating clip -2- such that dimension -a- at locking lever -4- is approx. 1 mm.
• ‒ Push up sleeve -3- at operating clip -2- and lock securing rod -1-.

Fig. 3    Removing cover for door handle

• ‒ → Lift door handle.
• ‒ Use small screwdriver to lever fastening strip out of door handle in direction of arrow and pull out.
• ‒ Remove door handle trim plate outwards.