A3 Mk2
Exploded view - input shaft |
Note
t | Mounting gearbox on assembly stand → Chapter |
t | Refer to → Electronic parts catalogue when installing new gear wheels. |
t | Lubricate all bearings on input shaft with gear oil before installing. |
1 - | Circlip |
q | For grooved ball bearing on input shaft → Item |
q | Removing and installing → Chapter |
2 - | Spacer |
q | Outside diameter = 78.6 mm |
q | Can only be fitted on modified gearbox housing (from gearbox manufacturing date 10 04 6 to approx. 20 01 8) → Chapter |
q | For correct version, refer to → Electronic parts catalogue |
3 - | Gearbox housing |
q | From gearbox manufacturing date 10 04 6 to approx. 20 01 8: modified in area of seat for grooved ball bearing → Item to match spacers → Item and → Item → Chapter |
q | From gearbox manufacturing date approx. 21 01 8 onwards, grooved ball bearing and bearing seat have flattened sides → Chapter |
q | For correct version, refer to → Electronic parts catalogue |
4 - | Spacer |
q | Outside diameter = 85 mm |
q | Can only be fitted on modified gearbox housing (from gearbox manufacturing date 10 04 6 to approx. 20 01 8) → Chapter |
q | For correct version, refer to → Electronic parts catalogue |
5 - | Circlip |
q | When grooved ball bearing → Item or input shaft → Item are renewed: determine thickness of required circlip → Fig. |
6 - | Grooved ball bearing |
q | Renew |
q | Pulling off → Fig. |
q | Pressing on → Fig. |
q | From gearbox manufacturing date approx. 21 01 8 onwards, grooved ball bearing and bearing seat have flattened sides → Chapter |
7 - | 5th gear wheel |
q | Pressing off → Fig. |
q | Installation position: Circular slot -arrow- faces towards grooved ball bearing → Item |
q | Pressing on → Fig. |
8 - | Input shaft |
q | With 3rd/4th and 6th gear wheels |
9 - | Roller bearing |
q | With circlip |
q | Pulling out → Fig. |
q | Pressing in → Fig. |
q | Installation position: Circlip in bearing faces towards input shaft |
10 - | Clutch housing |