A3 Mk2
Note
|
1 - | Dual-mass flywheel |
q | Removing and installing → Engine, mechanics; Rep. Gr.13 |
q | Ensure that dowel pins fit tightly |
q | Contact surface for clutch lining must be free of grooves, oil and grease |
q | Observe instructions for removal → Fig. |
2 - | Clutch plate |
q | Removing and installing → Chapter |
q | Always renew SAC pressure plate as well |
q | Installation position: marking “Getriebeseite” (gearbox side) faces towards gearbox |
q | For diameter of clutch plate, refer to → Electronic parts catalogue |
3 - | SAC pressure plate |
q | “SAC” = self adjusting clutch |
q | Always renew clutch plate as well |
q | Removing and installing → Chapter |
q | Checking position of adjuster ring on new SAC pressure plate → Fig. |
q | Checking ends of diaphragm spring → Fig. |
q | Checking spring connection and rivets → Fig. |
4 - | Bolt |
q | M6 - 13 Nm |
q | M7 - 20 Nm |
q | Loosen and tighten bolts consecutively in steps of 90° |