A3 Mk2
Exploded view - gearbox housing and selector mechanism |
1 - | Countersunk bolt, 33 Nm |
2 - | Flange shaft |
q | Removing and installing → Chapter |
q | Assembling → Chapter |
3 - | Circlip |
q | For sealing cap → Item |
q | Fitted from gearbox manufacturing date approx. 21 01 8 onwards (introduced gradually) |
4 - | Sealing cap |
q | Secured by circlip from gearbox manufacturing date approx. 21 01 8 onwards (introduced gradually) |
5 - | Circlip |
q | For grooved ball bearing on input shaft |
6 - | Reversing light switch -F4-, 20 Nm |
7 - | Seal |
q | Renew |
8 - | Oil drain plug |
q | Note the different versions |
q | Hexagon socket head bolt, 30 Nm |
q | Multi-point socket head bolt, 45 Nm |
9 - | Seal |
q | Renew |
10 - | Locking bolt for selector shaft, 30 Nm |
11 - | Bolt, 15 Nm + tighten 90° (1/4 turn) further |
q | With captive washer |
q | Renew |
q | Correct allocation of replacement bolts → Fig. |
12 - | Bolt, 15 Nm + tighten 90° (1/4 turn) further |
q | Without washer |
q | Renew |
q | Correct allocation of replacement bolts → Fig. |
13 - | Selector mechanism |
q | Dismantling and assembling → Chapter |
q | Removing with gearbox in vehicle: |
– | Remove battery and battery tray |
– | Remove selector cables and gearbox selector lever |
– | Unscrew locking bolt, pull out selector mechanism |
14 - | Bolt, 20 Nm |
q | Renew |
15 - | O-ring |
q | Renew |
16 - | Clutch housing |
q | Servicing → Chapter |
17 - | Gearbox housing |
q | Servicing → Chapter |
|