A3 Mk2
| Exploded view - input shaft, output shafts, differential and selector rods |
| 1 - | Output shaft for 1st - 4th gear |
| q | Dismantling and assembling → Chapter |
| q | Installation position → Fig. |
| 2 - | Selector rod with selector fork for 1st and 2nd gear |
| q | Installation position → Fig. |
| 3 - | Selector rod with selector fork for 3rd and 4th gear |
| q | Installation position → Fig. |
| 4 - | Output shaft for 5th, 6th and reverse gear |
| q | Dismantling and assembling → Chapter |
| q | Installation position → Fig. |
| 5 - | Selector rod with selector fork for 5th and 6th gear |
| q | Installation position → Fig. |
| 6 - | Reverse gear selector fork |
| q | Installation position → Fig. |
| 7 - | Input shaft |
| q | Dismantling and assembling → Chapter |
| q | Always renew grooved ball bearing on input shaft → Item |
| 8 - | Reverse shaft |
| q | With thrust washer |
| 9 - | Thrust washer |
| 10 - | Bleeder connection |
| q | Connect to slave cylinder → Item |
| 11 - | Clutch housing |
| q | Servicing → Chapter |
| 12 - | Input shaft oil seal |
| 13 - | O-ring |
| q | Renew |
| q | Push onto pipe connection |
| q | Lubricate with brake fluid before installing |
| 14 - | Slave cylinder with release bearing |
| 15 - | Bolt |
| q | For metal slave cylinder, 12 Nm |
| q | For plastic slave cylinder, 15 Nm |
| q | 3x |
| q | Renew |
| 16 - | Countersunk bolt, 33 Nm |
| 17 - | Stub shaft or flange shaft |
| q | Flange shaft has been installed from gearbox manufacturing date 01 11 4 onwards |
| q | For correct version, refer to → Electronic parts catalogue |
| q | Assembling → Chapter |
| 18 - | Differential |
| q | Dismantling and assembling → Chapter |
