A3 Mk2
| Exploded view - servicing clutch release mechanism |
| 1 - | Release bearing |
| q | Remove and install together with release lever → Item and guide sleeve → Item → Chapter |
| q | Do not wash out; wipe clean only |
| q | Renew bearing if noisy |
| 2 - | Clutch release lever |
| q | Remove and install together with release bearing → Item and guide sleeve → Item → Chapter |
| q | Remove existing grease |
| q | Lubricate surface which contacts ball-head pin with grease -G 000 100- |
| 3 - | Retaining spring |
| q | Secure to clutch release lever |
| 4 - | Bolt |
| q | 5 Nm + 90° |
| q | Always renew |
| 5 - | Guide sleeve |
| q | Remove and install together with release bearing → Item and release lever → Item → Chapter |
| 6 - | Ball-head pin, 20 Nm |
| q | Remove existing grease |
| q | Lubricate with grease -G 000 100- |
| 7 - | Input shaft oil seal |
| q | Renewing → Chapter |
| 8 - | Clutch slave cylinder |
| q | Removing and installing → Chapter |
