Audi Workshop Service and Repair Manuals > A3 Mk2 > Power unit | 4-cylinder direct petrol injection engine (1.4 ltr. 4-valve turbo), mechanics | Engine assy,cylinder block,crankcase | Assembly mountings | Checking adjustment of assembly mountings (engine/gearbox mountings)

Checking adjustment of assembly mountings (engine/gearbox mountings)

Procedure

–	Check distances at mounting (right-side) for engine and gearbox:

l	The two bolt heads -2- must be parallel with edge of support arm -3- for engine mounting.

l	There must be a distance of -x- = 12 mm between engine mounting -1- and timing chain cover -4-.

Note

Distance -x- = 12 mm can also be checked with a metal rod of suitable size, or similar.

–	If the distance measured is too large or small, the assembly mountings must be adjusted → Chapter.

Vehicles with manual gearbox:

–	Ensure that the edges of the support arm -2- (on the gearbox assembly mounting) and gearbox support -1- are parallel.

l	Dimension -x- must be identical on both sides.

Vehicles with dual clutch gearbox:

–	Ensure that the edges of the support arm -2- (on the gearbox assembly mounting) and gearbox support -1- are parallel.

l	Dimension -x- must be identical on both sides.

Audi Workshop Service and Repair Manuals