audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Dismantling and assembling shift mechanism without Tiptronic > < Checking and installing selector lever cable in shift mechanism with Tiptronic
Automatic Gearbox 01VFWD and 4WD
Servicing shift mechanism
Removing and installing locking cable at shift mechanism with Tiptronic
 
N37-0428

Removing

  • ‒ Shift selector lever into position "2".
  • ‒ Observe or obtain radio code on vehicles with coded radio.
  • ‒ Disconnect earth strap on battery.
  • ‒ Detach selector lever handle .
  • ‒ Remove the front section of the centre console

=> General Body Assembly, Interior; Repair group 68; Shelves and trays/covers; Removing and installing front part of centre console

 
N37-0428
  • ‒ Remove steering wheel:

=> General Body Assembly, Interior; Repair group 69; Airbag; Removing and installing steering wheel

  • ‒ Turn ignition key to "ignition on" position.
  • ‒ Move selector lever to position "P".
  • ‒ Lift locking clip on locking device -1- and withdraw interlock cable from ignition/starter switch.
  • ‒ Remove cover with guide (selector lever mechanism) .
  • ‒ Unclip interlock cable from securing spring on bearing cup, to do this lift securing spring slightly => Fig.37-21.
  • ‒ Release interlock cable from cable tie -2- and remove.
 
N37-0428

Installing

  • ‒ Route interlock cable free of kinks.
  • ‒ Turn ignition key to "ignition on" position.
  • ‒ Fit interlock cable to ignition/starter switch.
  • ‒ Check that locking device -1- engages.
  • ‒ Secure interlock cable with cable tie -2- to airbag sensor.
  • ‒ Turn ignition/starter switch to locked position ("ignition off").
  • ‒ Move selector lever to position "P".
  • ‒ Clip interlock cable into securing spring of bearing cup => Fig.37-21.
  • ‒ Hook interlock cable support bracket -3- into shift mechanism and interlock cable eye into lever (for interlock cable).
 
N37-0428

Adjusting

  • ‒ Move selector lever to position "P".
  • ‒ Unfasten bolt -6-.
  • ‒ It must be possible to slide the support bracket -3- in the direction indicated by the arrow -5-.
  • ‒ Move steering column down.
  • ‒ Attach setting gauge 3352 A -Item 4- between lever (for interlock cable) and interlock cable eyelet.
  • ‒ Pull interlock cable in direction of arrow -5- and tighten bolt -6- to 10 Nm.
  • ‒ Remove setting bar.
  • ‒ Check ignition key withdrawal lock after each adjustment of interlock cable => Page 37-1.
 
N37-0428
  • ‒ Install steering wheel.

=> General Body Assembly, Interior; Repair group 69; Airbag; Removing and installing steering wheel

  • ‒ Reinstall front section of the centre console.

=> General Body Assembly, Interior; Repair group 68; Shelves and trays/covers; Removing and installing front part of centre console

  • ‒ Attach selector lever handle .
  • ‒ Reconnect earth strap to battery.
  • ‒ On vehicles with coded radio unit, activate code.

Dismantling and assembling shift mechanism without Tiptronic > < Checking and installing selector lever cable in shift mechanism with Tiptronic