A4 Mk2
Note
|
|
|
Caution
|
|
| 1 - | Locking cable |
| – | Lift up retaining clip -2- on locking device and pull locking cable -1- out of ignition/starter switch. |
| – | Lift up securing spring -4- for locking cable. Pull locking cable support bracket -5- sideways off the selector mechanism, then disengage locking cable eye. |
| 1 - | Locking cable |
| Installing |
| Installation is carried out in reverse sequence; note the following: |
| – | Route locking cable behind dash panel brace -arrow- without kinking. |
| – | Turn ignition key to "ignition on" position. |
| – | Insert locking cable -1- into ignition/starter switch. |
| – | Check that locking device -2- engages. |
| – | Turn ignition/starter switch to locked position (ignition off). |
| – | Make sure that selector lever is in position “P”. |
| – | Hook eye of locking cable onto pin -3-. |
| – | Lift up securing spring -4- slightly. |
| – | Insert locking cable support bracket -5- into the selector mechanism from the right. Push it in so that securing spring -4- engages. |
| – | Adjust locking cable → Chapter. |
| – | Install selector mechanism cover → Chapter. |
| – | Install ashtray in centre console → Rep. Gr.68. |
| – | Install air conditioner operating unit → Rep. Gr.87. |
| – | Install cover for steering column → Rep. Gr.68. |
| – | Install storage compartment (driver's side) → Rep. Gr.68. |
| – | Follow the steps required after connecting the battery → Rep. Gr.27. |
