audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking oil pressure and oil pressure switch > < Oil filter and oil cooler - exploded view of components

A4 Mk2

Removing and installing oil filter bracket
Removing and installing oil filter bracket
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
Removing
–  Drain off coolant → Chapter.
–  Remove coolant pipe (bottom) → Chapter.
  W00-10211
–  Place used oil collection and extraction unit -V.A.G 1782- under engine and remove oil filter -1-.
–  Note installation position and remove oil cooler -2-.
  A17-10074
–  Unplug electrical connector -3-.
–  Remove bolt -1- for oil supply pipe on oil filter bracket.
–  Detach clip -2- and remove crankcase breather pipe.
–  Unscrew bolts -arrows- and remove oil filter bracket.
Installing
Installation is carried out in the reverse order; note the following:
  Note
Renew gaskets, seals and O-rings.
–  Install coolant pipe (bottom) → Chapter.
–  Check oil level → Chapter.
–  Fill cooling system → Anchor.
Tightening torques
  A17-10075
ComponentNm
Oil filter bracket to cylinder block15 + 90° → Remark → Remark
Oil supply pipe to oil filter bracket30
Oil cooler to oil filter bracket25
Oil filter to oil cooler20

1)  Renew bolts.
2)  90° equals a 1/4 turn.
   

Checking oil pressure and oil pressure switch > < Oil filter and oil cooler - exploded view of components