audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing convenience system central control unit J393 > < Removing and installing 4-position relay carrier

A4 Mk2

Removing and installing connector point (left-side)
Removing and installing connector point (left-side)
   
Removing
t  Fitting location: connector point (left-side) -arrow- is located in footwell (left-side) beneath A-pillar trim.
–  Switch off ignition and take out ignition key.
–  Remove A-pillar trim → Rep. Gr.70.
–  Press retaining clip and detach connector point from A-pillar -arrow-.
–  Unclip fuse holder at connector point.
–  Withdraw relays or control units and then unclip appropriate relay carrier.
  Note
Exact assignment of connector point can be found in appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
–  Install A-pillar trim → Rep. Gr.70.
  A97-0270

Removing and installing convenience system central control unit J393 > < Removing and installing 4-position relay carrier