A4 Mk3
Note
|
| 1 - | Bolt |
| q | 30 Nm |
| 2 - | Protective cap |
| q | Insert in brake caliper |
| q | Renewing → Chapter |
| 3 - | Guide pin |
| q | Slide through sleeve |
| q | Renewing → Chapter |
| 4 - | Protective cap |
| q | Push onto bleeder valve |
| 5 - | Bleeder valve |
| q | Before screwing in, grease thread with thin coat of assembly paste -G 052 150 A2-. |
| q | 15 Nm |
| 6 - | Brake caliper housing |
| 7 - | Retaining spring |
| q | Ensure correct installation position |
| 8 - | Protective cap |
| q | Do not damage when inserting piston |
| q | Grease with assembly paste -G 052 150 A2-. |
| 9 - | Piston |
| q | Apply a thin coat of assembly paste -G 052 150 A2- to piston before inserting |
| q | Diameter 57 mm |
| 10 - | Seal |
| q | Grease with assembly paste -G 052 150 A2- |
| 11 - | Brake carrier |
| q | Removing and installing → Chapter |
| q | The retaining pins (4x) for the brake pads on the brake carrier must NOT be slackened |
| 12 - | Bolt |
| q | 196 Nm |