Note t
| The ATF lines can only be removed and installed with the gearbox removed from the vehicle. |
–
| Place used oil collection and extraction unit -V.A.G 1782- below connection. |
–
| Unscrew union nuts -arrows-. |
–
| Seal off open lines and connections with clean plugs from engine bung set -VAS 6122-. |
Installation is carried out in reverse sequence; note the following: |
Note
Caution Risk of damage to gearbox |
t
| All plugs from engine bung set -VAS 6122- which were inserted in ATF lines and gearbox when dismantling must be removed. |
t
| If you forget to remove the plugs, the ATF cooling will be ineffective and the gearbox will be damaged. |
|
–
| First press ATF lines onto gearbox and cooler by hand until they engage, then bolt on. |
–
| After installing gearbox, check and correct ATF level → Chapter. |
|
|
|