audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Checking selector mechanism > < Guided Functions for gearbox

A4 Mk3

Exploded view - selector mechanism
Exploded view - selector mechanism
Overview:
t  → Chapter „Checking selector mechanism“
t  → Chapter „Manual release for selector mechanism“
t  → Chapter „Removing and installing selector lever lock solenoid -N110-“
t  → Chapter „Removing and installing selector lever sensors control unit -J587-“
t  → Chapter „Removing and installing gear selector position P switch -F305-“
t  → Chapter „Removing and installing shift unit“
  WARNING
Accidents and injury can be caused if a gear is inadvertently engaged while the engine is running.
Prior to performing work with engine running, move selector lever to position „P“ and pull up parking brake button to apply the electromechanical parking brake.
Check selector mechanism before dismantling → Chapter.
   
1 - Selector lever handle
q   → Chapter „Exploded view - selector lever handle, selector lever position display -Y26-“
2 - Trim ring
q   → Chapter „Exploded view - selector lever handle, selector lever position display -Y26-“
3 - Selector lever boot
q   → Chapter „Exploded view - selector lever handle, selector lever position display -Y26-“
4 - Clamp
q   → Chapter „Exploded view - selector lever handle, selector lever position display -Y26-“
5 - Selector lever position display -Y26-
q   → Chapter „Exploded view - selector lever handle, selector lever position display -Y26-“
6 - Nut
q   Secures selector mechanism to body
q   4x
q   10 Nm
7 - Gasket
8 - Selector lever sensors control unit -J587- and tiptronic switch -F189-
q   → Chapter „Removing and installing selector lever sensors control unit -J587-“
9 - Shift unit
q   Can only be renewed as a complete unit
q   → Chapter „Removing and installing shift unit“
l  After removing and installing the shift unit, run the appropriate „Guided Function“ using the vehicle diagnostic tester → Chapter.
10 - Selector lever lock solenoid -N110-
q   → Chapter „Removing and installing selector lever lock solenoid -N110-“
11 - Gear selector position P switch -F305-
q   Consists of two reed contacts on printed circuit board in selector lever lock solenoid -N110-
q   Can only be renewed together with selector lever lock solenoid -N110- → Chapter „Removing and installing selector lever lock solenoid -N110-“
12 - Noise insulation
q   Not fitted on all vehicles
q   For correct version, refer to → Electronic parts catalogue
13 - Retaining washers
q   Renew
q   4x
q   For securing noise insulation to shift unit
14 - Retaining clip
q   Secures selector lever cable to shift unit
15 - O-ring
q   Renew
16 - Selector lever cable
q   Do not bend or kink
q   → Chapter „Exploded view - selector lever cable“
17 - Cover plate
q   Above selector lever lock solenoid -N110-

   

Checking selector mechanism > < Guided Functions for gearbox