| Calibrating reversing camera system |
| After performing service work on the vehicle it may be necessary to re-calibrate the reversing camera system. This is required after: |
| t
| Removing and installing reversing camera -R189- |
| t
| Renewing reversing camera system control unit -J772- |
| t
| Performing accident repair work on rear lid |
| t
| Performing repair work on rear axle |
| Requirements for calibration |
| t
| Camera lens must be clean. |
| t
| Vehicle must be positioned on a firm and even surface. |
| t
| There must be sufficient space around the vehicle. |
| t
| Parking brake must be activated. |
| t
| Steering wheel must be in centre position, wheels must be straight. |
| t
| All doors and the rear lid must be closed. |
| t
| There must not be anyone inside the vehicle. |
| t
| Vehicle must not be loaded (unladen weight). |
| t
| Switch on ignition before every calibration. |
| Setting up and aligning calibration unit -VAS 6350- → Chapter. |
| Calibrating reversing camera -R189- → Chapter. |
|
|
|
