audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

ABOUT US
Removing and installing mechatronic unit for dual clutch gearboxJ743 > < Removing and installing ATF oil pan

A5

Removing and installing ATF intake filter
Removing and installing ATF intake filter
Special tools and workshop equipment required
   
t  Used oil collection and extraction unit -V.A.G 1782-
  W00-10211
Removing
  Note
t  General repair instructions → Chapter.
t  Rules for cleanliness when working on the dual clutch gearbox → Chapter.
–  Remove ATF oil pan → Chapter.
–  Place used oil collection and extraction unit -V.A.G 1782- below gearbox.
–  Carefully pull ATF intake filter off mechatronic unit towards rear in direction of -arrow-.
  A34-10483
Installing
Installation is carried out in reverse sequence; note the following:
–  Fit O-ring -2- to support (rear) on ATF intake filter -1-.
–  Carefully insert intake neck of ATF intake filter into opening on oil pump as far as stop.
l  It must be possible to insert support with O-ring into hole on gearbox housing.
–  Install ATF oil pan → Chapter.
–  Fill up with ATF → Chapter.
  A34-10422

Removing and installing mechatronic unit for dual clutch gearboxJ743 > < Removing and installing ATF oil pan