A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Counterhold driveshaft using a suitable lever - 2 - and tighten bolts - 1 - at front and rear.
-
Remove Assembly appliance (3139).
Center Bearing, Aligning
-
Slightly loosen securing bolts for center bearing.
-
Slide driveshaft forward as far as it will go and mark position of center bearing on body - arrow A -.
-
Slide driveshaft to rear as far as it will go and mark position of center bearing on body - arrow B -.
-
Push driveshaft to right as far as it will go and mark position of center bearing on body - arrow 1 -.
-
Push driveshaft to left as far as it will go and mark position of center bearing on body - arrow 2 -.
-
Align driveshaft centrally - arrow C and arrow 3 -.
‹› Center bearing must be positioned centrally between markings - A - and - B - and markings - 1 - and - 2 -