Q5 Quattro V6-3.2L (CALB) (2009)
‹› Wear protective gloves and eyewear.
‹› To avoid damaged electrical wires in the headlamp housing, do not cut too deep.
-
Cut the cover - 5 - out of the headlamp housing with a sharp box cutter.
-
Open the retainer - 2 -.
-
Move the housing cover - 1 - to the side and remove it.
-
Turn the headlamp range control positioning motor - 4 -.
‹› Left headlamp counter-clockwise.
‹› Right headlamp clockwise.
-
Push the ball end of the positioning stem upward and out of the ball end mount by swiveling the control motor.
-
Remove the control motor.
-
Disconnect the electrical connector - 3 -.
Installing
‹› Tightening specification. Refer to => [ Bi-Xenon Headlamps with Cornering Lamp, Assembly Overview ] See: Service and Repair/Bi-Xenon
Headlamps with Cornering Lamp, Assembly Overview.
Install in reverse order of removal, observing the following:
-
Connect the electrical connector when guiding in.
-
Start by inserting ball end of positioning stem from underneath in reflector socket. To do so, pull reflector to rear.
-
Position and lock the headlamp range control motor bayonet connection on the headlamp housing.
‹› Left headlamp clockwise.
‹› Right headlamp counter-clockwise.
-
Close the opening in the headlamp with the housing cover - 1 - from the repair set.
-
Tighten the bolts - arrows -.
-
Install the headlamp housing. Refer to => [ Headlamp Housing ] See: Service and Repair/Halogen Headlamps.