Q5 Quattro V6-3.2L (CALB) (2009)
/Page-246002.png)
-
Unlock connector - 3 - and disconnect it from the Electronic Damping Control Module (J250) - 1 -.
-
Remove the Electronic Damping Control Module ( J250) - 1 -.
Installing
Installation is in reverse of removal, with special attention to the following:
Tightening specification for the nuts. Refer to => See: Steering and Suspension/Suspension/Control Arm/Service and Repair/Front Suspension
-
Re-adapt the Electronic Damping Control Module ( J250). Refer to => [ Control Position, Programing using VAS 5051B ] See: Steering and
Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection.
