Q5 Quattro V6-3.2L (CALB) (2009)
/Page-247002.png)
-
Connect wiring harness connectors - 3 - to the control module - 8 -.
-
Carefully slide the wiring harness clip connection - 3 - into the bracket - 4 -.
-
Insert the control module with the bracket.
-
Connect the Ground (GND) wire - 2 - to the threaded pin and tighten the nuts - 1 - to 6 Nm.
-
Tighten nuts - 7 - to 6 Nm.
-
The system must be calibrated if the Active Steering Control Module Is Replaced (J792). Refer to => [ Adaptive Cruise Control Calibration
Procedure ] See: Cruise Control/Testing and Inspection.
Tightening Specifications
