Q5 Quattro V6-3.2L (CALB) (2009)
1. Nut (T10263/5)
2. Press Piece (T40185/4)
3. Subframe
4. Bonded rubber bushing or the hydraulic bonded rubber bushing
5. Press Piece (T40185/3)
6. Support ring (T10205/4)
7. Hydraulic Cylinder (VAS 6178)
8. Nut (T10263/5)
9. Spindle (T10263/4). The spindle pins face downward.
-
Align the bonded rubber bushing with the markings made previously and push it in until the collar comes in contact with the bushing in the
subframe without any gaps. Tension and repress over cylinder several times if necessary. While pulling in, make sure the bonded rubber bushing
does not cant, otherwise outer ring could be damaged.
-
The ends of the rubber bead on the bonded rubber bushing must align with the markings - arrows - on the subframe.