Q5 Quattro V6-3.2L (CALB) (2009)
‹› After replacing the bearing, fix any paint damage on the subframe with corrosion protection, primer and black top coat.
-
Attach the anti-twist mechanism to the bushing.
Further installation is in the reverse order to removal.
Replace the rear hydraulic bonded rubber bushing.
-
Loosen the nuts on both ends of the mufflers but only as far as to where the thread begins.
-
Place Engine/Transmission Jack (V.A.G 1383 A ) with Universal Transmission Support (V.A.G 1359/2 ) - 1 - under the subframe.
-
Place a wood block - 2 - under the subframe - 1 -.
-
Remove rear subframe bolts => [ (Item 20) Bolt ] See: Rear Subframe/Service and Repair.