Q5 Quattro V6-3.2L (CALB) (2009)
/Page-1316002.png)
‹› Replace
‹› Coat with ATF before inserting.
3
ATF line, return
‹› From the ATF cooler to the transmission.
‹› Before removal, mark the ATF lines in relation to each other so they are not switched.
4
O-ring
‹› Replace
‹› Coat with ATF before inserting.
5
ATF line, supply
‹› From transmission to ATF cooler.
‹› Before removal, mark the ATF lines in relation to each other so they are not switched.
6
Bolt
‹› 5 Nm
‹› First insert the ATF lines with new O-rings by hand until seated.
7
ATF line, supply
‹› From transmission to ATF cooler.
‹› Before removal, mark the ATF lines in relation to each other so they are not switched.
‹› Nuts on the ATF lines, 29 Nm.
‹› The ATF lines are secured to each other.
8
Bolt
‹› 8 Nm
9
Bracket
10
ATF line, return
‹› from the ATF cooler to the transmission.
‹› Before removal, mark the ATF lines in relation to each other so they are not switched.
‹› Nuts on the ATF lines, 29 Nm.
‹› The ATF lines are secured to each other.
11
Bolt
‹› 20 Nm
‹› First insert the ATF lines with new O-rings by hand until seated.
‹› The retaining tab on the lower ATF line must lie on the transmission threads.
‹› The retaining tab on the upper ATF line must lie on the lower one.
12
O-ring
