Q7 Quattro V6-3.6L (BHK) (2007)
Air Door Actuator / Motor: Service and Repair
Left Rear Temperature Flap Motor
Left Rear Temperature Flap Motor
‹› With Left Rear Temperature Flap Position Sensor (G391)
Removing
-
Switch ignition off
-
Bring rear heating & A/C unit into service position => [ Rear Heating and A/C Unit, Service Position ] See: Service and Repair/Removal and
Replacement/Rear Heating and A/C Unit, Service Position
-
Remove (unhook) lever - 1 - from Left Rear Temperature Flap Motor (V313).
-
Remove mounting bolts - 2 -.
-
Disconnect electrical connection from Left Rear Temperature Flap Motor (V313) and remove control motor.
Installing
-
Install the removed components again in reverse order.
-
Check DTC memory of front A/C control head Climatronic Control Module (J255) and of Rear A/C Control Head (Climatronic) (E265) and erase
DTCs displayed if necessary.
-
Perform basic setting (and output Diagnostic Test Mode (DTM) if necessary) on the A/C system.