Q7 Quattro V6-3.6L (BHK) (2007)
-
Check clearance of the insulation mat (in engine compartment) via opening - B - in floor plate - C -, it must be large enough so that it does not
contact the flap - D -, permitting condensation water to drain out from condensation water drain opening.
-
Check installation position of floor mat - E -, it must not constrict (compress) cross section of condensation water drain hose - A -.
-
Condensation water drain of heating A/C unit - B - for soiling (e.g. using a piece of wire) and clean it if necessary.
-
Insert condensation water drain into opening in lower floor plate - C -.
-
Connect condensation water drain hose - A - on proper side to condensation water drain of heating A/C unit - B - (opening of flap - D - must
be at bottom) and secure the connection if necessary using a clamp.
-
Check installation position of floor carpet, it must not constrict (compress) cross section of condensation water drain hose - A -.
-
Install instrument panel trim under glove compartment.
NOTE:
-
Condensation water hose must fit securely on connection of heating A/C unit.
-
Condensation water hose to valve (flap) must not be kinked or pinched.