RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-2397003.png)
-
Remove tie rod downward out of steering arm or press out.
‹› Do not use a chisel or similar tool between steering arm - 1 - and tie rod ball joint sealing washer - 2 - when removing tie rod, otherwise sealing
washer could be damaged.
‹› Tie rod may only be pressed off steering arm over tie rod ball joint pin ends or driven with a wooden or rubber hammer.
-
Secure wheel bearing housing - 1 - at left with help of tensioning band - 2 - at suspension strut - 3 -.
-
Remove panel nut - arrow -.
