S4 V8-4.2L (BHF) (2004)
-
Check adjustment of switch -1- above clutch pedal as follows:
^
Switch -1- must lie against clutch pedal -3- completely and must be completely activated.
^
Adjustment tolerance: gap measurement-a- between retaining clip and mounting bracket -2- or gap measurement -b- at switch -1- may be a
maximum of 0.5 mm.
^
To adjust, hold clip and rotate switch -1 -.
Note: Connect clutch master cylinder with clutch pedal. Engage bolt lock in clutch pedal.
-
Remove driver's side storage compartment:
-
Always replace seal -C-.
-
Make sure seal does not cover chassis opening and elevated edge of sheet metal.
-
Insert E-Box in securing point -B- and tighten nuts -A- to 4 Nm.
-
Press cover on by hand and tighten bolts -A- diagonally to 4 Nm (also see inscription on cover).
-
Install engine wiring harness and connect harness connector in connector station.
-
Install engine control module and if necessary, auxiliary relay carrier and auxiliary fuse holder.