S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
-
Mark center of anchor point hole on rear of filler panel trim.
-
Remove rear filler trim panel.
-
Drill a 8.0 mm (5/16 in.) starter hole in rear filler trim panel at center mark.
-
Enlarge hole to dimensions shown.
^
Measurements in mm
CAUTION: Washer -7- is only to be riveted to the rear filler panel sheet metal.
-
Using pop-rivets 6, mount washer 7 to under side of filler panel sheet metal.
-
Mount spacer sleeve 4, anchor bracket 3.
-
Install bolt 2.
Tightening torque: 25 Nm (18 ft lb)
-
Install cover 1 onto anchor bracket.
NOTE: Cap 8 is only used to cover hole in rear filler panel trim when anchor bracket is removed or not in use.