S6 Wagon L5-2226cc 2.22L DOHC Turbo (AAN) (1995)
![background image](/audi/s6_wagon/l5-2226cc_2.22l_dohc_turbo_(aan)/Page-2585004.png)
-
Install carrier in steering gear boot and fasten with both bolts.
-
Install steering gear through opening in right wheel housing (two technicians required).
-
Ensure correct routing of wiring harness, install cable tie.
-
Carefully install instrument panel seal.
-
Fasten steering gear on left and right wheel housing.
-
Install mounting bracket for left-side ABS wheel speed sensor and clip on sensor connector.
-
Remove left bolt from carrier for tie rod mounting.
-
Install left tie rod in carrier and loosely thread in mounting bolt.
-
Remove right tie rod from carrier.
-
Install right tie rod in carrier and loosely thread in mounting bolt.
-
Tighten both mounting bolts to specified torque only with vehicle standing on wheels.
-
Ensure correct seat of carrier in steering gear boot.
-
Fasten return and pressure hoses on rotary slide valve housing so hoses do not touch at any point.
-
Remove hose clamps, Snap-On YA2850 or equivalent, from power steering return and pressure hose.
-
Carefully place sound insulation mats under pedals.
-
Install brake lines according to markings on ABS hydraulic unit.
-
Install brake lines and fuel line in brackets.
-
Bleed brake hydraulic system and check for leaks
-
Ensure correct position of steering wheel.
-
Connect battery Ground (GND) strap.
-
Check and/or top off power steering fluid, check return and pressure hoses on rotary slide valve housing for leaks.