TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
19 - Bolt
‹› 25 Nm
‹› Also secures heat shield
20 - Rear driveshaft tube
‹› Do not damage centering bushing - 5 - and seal when removing and installing in center of flange
‹› Clamp to loosen and tighten bolted connections, refer to => [ Rear Driveshaft Tube, Clamping in Vise with ] See: Overhaul
21 - Centering bushing
22 - Bolt
‹› 60 Nm
‹› Allocation, refer to => [ Note location of various collar bolts ] See: Driveshaft with Separable Center Support, through 05.2007, Installing
23 - Balance nut
‹› 10 Nm
‹› Not present on all driveshafts
‹› If collar bolt was loosened , balance nut and balance bolt must not be reinstalled
24 - Balance disc
‹› Only present in balanced final drive
25 - Bolt
‹› 50 Nm plus an additional 90° turn
‹› Always replace
26 - Flexible disc with vibration dampener
‹› Location, refer to => [ Flexible Disc with Vibration Damper, Installation
Location ] See: Overhaul
27 - Rear Final Drive
‹› Removing and installing, refer to => [ Rear Final Drive Assembly Overview ] See: Differential Assembly/Service and Repair/Removal and
Replacement/Rear Final Drive Assembly Overview