3 Series E36 325tds (M51) TOUR
Unfasten screws and lift up oil pan.
Installation:
Sealing faces clean and free of seal debris.
Replace seal.
Fit gasket to oil pan or engine block and apply a bead of three
Bond 1209 (refer to BMW Parts Service) flexible sealing
compound to recesses at front and back: bead should be
approx. 3 mm wide and 2 mm high.
Installation:
Insert all screws in oil pan.
Fit screws on transmission end, without preload at this stage.
Tighten down screws on engine end.
Tighten screws on transmission end.
RA Removing and installing, sealing or replacing oil pan ( M51 from 9 / 92 )
BMW AG - TIS
08.02.2013 18:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
