3 Series E46 316i (M43TU) SAL
Apply light coat of oil to connecting-rod bearing shells.
Place bearing caps in position, making sure that matching
numbers are paired.
Install new conrod bolts.
Secure conrod with special tool 00 9 120.
Tightening Torque,
refer to Technical Data 11 24 1AZ.
Version with oil spray nozzles on underside of cylinder
Attach special tool 11 7 320 to the intake side in the receiving
bore hole in the engine block.
Note:
In engines with balancing shafts, the adjustment of the oil
spray nozzles can only be checked on cylinders 1 and 2
with special tool 11 7 320.
The spray nozzles must fit into the guide of special
tool 11 7 320.
If necessary, loosen the spray nozzles and adjust and tighten
them using special tool 11 7 320.
Tightening Torque,
refer to Technical Data 11 11 7AZ.
Assemble engine.
RA Removing and installing or replacing all pistons (M43 / M43TU)
BMW AG - TIS
19.01.2013 10:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -
