3 Series E46 316i (M43TU) SAL
13 62 560
Removing and installing or replacing air-mass
flow sensor (M43TU)
Turn off ignition.
Release hose clip (1) on inlet hose.
Disconnect plug connection (2) on air-mass flow sensor.
Unlock clamps (3) on intake filter housing and remove air-mass
flow sensor.
Installation:
Check gasket (1) between air-mass flow sensor and air
cleaner upper section for damage, replace if damaged.
To facilitate joint between air cleaner and throttle assembly,
coat gasket with acid-free grease.
Installation:
Only reinstall mass air flow sensor with undamaged lattice
frame.
Read out fault memory of DME control module, check stored fault
messages, rectify faults, cancel fault memory.
RA Removing and installing or replacing air-mass flow sensor (M43TU)
BMW AG - TIS
19.01.2013 11:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
