3 Series E46 316i (M43TU) SAL
Note:
E46/16 (4WD)
Observe installation position of axial lock (spacer bushing) on
manual shift valve shaft between transmission switch and
housing.
Removal of manual shift valve shaft is opposite to that shown in
Fig. R24 0433.
Drive spring pin (1) out of transmission switch (2).
Withdraw manual shift valve shaft (3) from transmission only so
far that transmission switch (2) can be removed.
Important!
Do not remove parking gear rack.
Do not move parking gear rack more than 10 mm; if
necessary, secure with pointed pliers.
Release notched disk on parking gear rack.
Remove transmission switch (2) with detent disk.
Remove transmission switch (1) from detent disk (2).
Installation:
Bore holes for spring pin in transmission switch (1) must
overlap with bore holes of detent disk (2) and manual shift
valve shaft.
Installation:
Attach parking gear rack (1) from rear in detent disk (2).
Slide in manual shift valve shaft.
Drive in spring pin.
Important!
During entire installation work, journal (3) must be aligned
vertically to manual shift valve shaft.
After installation of detent spring, ensure that parking lock
functions correctly.
Press journal (3) forwards into "P" position, rotate propeller
shaft and check that locking pawl engages.
RA Replacing transmission switch (A5S 360R / 390R, A4S 200R)
BMW AG - TIS
19.01.2013 12:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
