3 Series E46 316i (M43TU) SAL
The adhesive labels, part number 66 12 8 381 059, can be ordered via the usual part
ordering channels.
In the interest of a standard differentiation between keys with remote control, the following
colour marking is recommended:
Key 1
Grey adhesive label
Key 2
Green adhesive label
Key 3
Red adhesive label
Key 4
Blue adhesive label
Initialising keys - ordering additional keys
As a rule, the two keys with remote control supplied with the vehicle at delivery are already
initialised. If this is not the case, or if a third or fourth key with remote control is ordered,
proceed as follows:
Keys with remote control which have not been initialised must be first be initialised - please
refer to Owner's Handbook.
The initialisation sequence is of vital importance for the numbering of the keys.
The first key to be initialised automatically receives the number 1 and should therefore be
given the grey label in accordance with our recommendation.
Please note:
The numbers of the keys may be different from the numbers required to cancel the keys in
the EWS diagnostic program.
New terms
"Factory setting"
If "factory setting" is selected, the vehicle will be programmed without regard for the
individually programmed settings in the central encoding key (ex work delivery condition).
All setting differing form the "factory settings" are lost.
Please note:
If the passenger seat occupancy detector was deactivated, this function must be carried out
again with the program "Encoding Body/Suspension" after selecting "factory settings".
Seat occupancy detector deactivation is not documented in the central encoding key.
Airbag deactivation is documented in the central encoding key and will remain active after
"factory setting" is selected.
"Cancel selection"
If "cancel selection" is selected, the "wish list" compiled by the programmer is cancelled.
New settings can then be selected.
"Program vehicle"
If "Program vehicle" is selected, the individual functions in the "wish list" are programmed
into the individual systems. The settings can be printed out in full before programming.
Symbols
In the course of the program, new symbols will appear before the possible function settings:
The "*" symbol marks a "factory setting"
The "*" symbol indicates that the marked setting corresponds to the "factory setting" in the
central encoding key.
The "=" symbol marks the "current setting"
The "=" symbol indicates that the marked function is currently active in the vehicle. If there
IDC BMW DIS E46 Car and Key Memory
BMW AG - TIS
19.01.2013 21:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
