5 Series E34 525td (M51) TOUR
Caution!
Version with injection pump bearing block:
Before installing the gasket, fill the V-shaped recess with
permanently elastic Drei Bond 1209 sealing compound,
see BMW Parts Service, at the sealing strip for injection
pump bearing block.
Installation:
Install timing case cover, insert all screws and initially tighten
to approx. 5 Nm.
Fully tighten all screws in alternate sequence.
Tightening torque,
refer to Technical Data 11 14 1AZ.
Caution!
If all screws are tightened, they must be tightened again in a
second operation.
Replace radial seal in timing case cover at bottom,
refer to 11 14 141.
Install cylinder head,
refer to 11 12 100.
Reattach special tool 00 0 200, lower front axle support again
and install oil sump,
refer to 11 13 000.
Assemble engine.
RA Removing and installing, sealing or replacing timing case cover at bottom (M51)
BMW AG - TIS
23.01.2013 06:35
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -