5 Series E34 525td (M51) TOUR
Heat output flange to approx. 80
°
C (hot-air blower).
Push output flange onto output shaft.
If necessary, drive on to fit tight with special tool 23 1 160 .
Fit collar nut (1) with flat side pointing to output flange with screw
retaining compound, refer to BMW Parts Service.
Grip output flange with special tool 23 0 020 .
Secure collar nut with drive socket 23 2 320.
Tightening torque, 23 21 1AZ.
Heat ball bearing inner race (2) for countershaft to approx. 80
°
C
(hot-air blower).
Press on ball bearing inner race (2) with special tool 23 1 160
until firmly seated, drive on with gentle taps if necessary.
Install washer (3) and screw (4) with screw retaining compound,
refer to BMW Parts Service.
Caution!
Screw (4) has left-hand thread.
RA Removing and installing complete drive and output shafts (S5D 260Z / 310Z / 320Z
BMW AG - TIS
23.01.2013 07:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 10 -
