5 Series E34 525td (M51) TOUR
Drive in cotter pin (2).
Screw in all case screws and tighten down.
Tightening torque,
refer to Technical Data 23 11 1AZ.
Loosen bolt (1).
Install screw (2) with Loctite 243 locking varnish.
Tighten the screws (1 and 2).
Tightening torque,
refer to Technical Data 23 11 6AZ.
Install radial seal for selector shaft and output shaft.
Coat sealing lip with ATF-oil.
Push in output shaft radial seal with special tool 24 0 110 and
selector shaft radial seal with special tool 23 1 240.
Note:
Use a plastic hammer to drive in seal.
RA Complete removal and installation of input and output shafts (S5D 200G/ 250G)
BMW AG - TIS
23.01.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -