5 Series E34 525td (M51) TOUR
Bearing of output shaft in front case section:
Remove selector arm (1). For this purpose, unscrew screws (4
and 5). Remove bracket (3), spring (2) and selector arm (1).
Remove retaining plate (6).
Remove output shaft bearing with special tool 23 1 340 and
handle 00 5 500 from the outside to the inside.
Heat the front case section in the area near the bearing to
approximately 80
°
C (hot air blower).
Install bearing, using, if necessary, special tool 23 1 470 and
handle 00 5 500 until securely driven into place.
Bearing outer race of countershaft in front case section:
Insert special tool 23 1 280 into the bearing shell (1).
RA Replacing bearings on all gearshafts (S5D 200G/ 250G)
BMW AG - TIS
23.01.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
