5 Series E34 525td (M51) TOUR
Apply Special tool 33 4 020.
Screw on Special tool 23 1 300.
Pull bearing shell out.
Installation:
Insert bearing shell (1) that the slot in the bearing shell is
aligned with beads (2) (turning lock) in the case.
Push in bearing shell (1) with special tool 23 1 260 and handle
00 5 500.
Locking device (2).
Install retaining plate.
For this purpose, push locking bolt (2) outward with a screw (1).
Push the locking bolt (3) outward with a screwdriver (4).
Install retaining plate and secure with screws.
Install screws with Loctite 243 screw locking varnish.
Tightening Torque,
refer to Technical Data 23 11 17AZ.
Remove screw (1).
RA Replacing bearings on all gearshafts (S5D 200G/ 250G)
BMW AG - TIS
23.01.2013 07:12
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
