5 Series E34 525td (M51) TOUR
Unfasten screws with special tool 24 5 180.
Installation:
Drive out centering pins with a screwdriver.
Tighten screws crosswise.
Tightening torque,
refer to Technical Data 24 11 3AZ.
Lift converter bell housing off with oil pump.
Remove spacer disc (1), gasket (2) and seal (3) from oil pump.
Note:
When cleaning the sealing faces, ensure that no gasket
residue drops into the transmission.
Installation:
Secure spacer disc (1) on oil pump with Vaseline.
Stick new gasket (2) to oil pump housing with Vaseline,
carefully aligning the hole pattern.
Coat new seal (3) with Vaseline and place on oil pump.
Remove rectangular rings (1) from turbine shaft (2).
Coat new open rectangular ring (1) with Vaseline and insert in
lower groove in turbine shaft (2).
Coat new closed rectangular ring (3) with Vaseline, widen slightly
and install in upper groove in turbine shaft (2).
RA Removing and installing/sealing converter bell housing (A4S 270R/310R)
BMW AG - TIS
23.01.2013 07:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
