5 Series E34 525td (M51) TOUR
Press out drive pinion.
Caution!
Be careful not to damage threads.
Extract front outer bearing race with special tool 33 1 350.
(1) Spreader
(2) Front bearing outer race
(3) Puller bell housing
(4) Bolt
Remove rear outer bearing race with special tool
33 1 360/351/362/356/363.
Caution!
The shim (X) is located below the rear outer bearing race. It
will be needed again for pinion/crown wheel adjustments.
Measure and note down thickness of shim (X), e.g. X = 4.14
mm.
Install old shim (X) in front of rear outer bearing race. Fit new outer
bearing race with special tool 33 1 354 / 362 / 363 / 360 / 365 /
366 / 367.
RA Replacing drive pinion with crown wheel (Type G) - final drive removed -
BMW AG - TIS
23.01.2013 07:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -