5 Series E34 525td (M51) TOUR
VK-22, Siefermann
Register/Index: 2
2 02 96 (047)
vertrieb
Deutschland
KDL d. VGs und
Imp. z. Info
02/1996
Adapter for measuring stall current
All model series
Situation:
The adapter is required for measuring the stall current. It is designed in such a manner that
the power supply for the entire vehicle electrics and vehicle electronics system is not
interrupted during installation or when carrying out measurements. A label is also included
so that it can be stored in the cable cupboard.
Please follow the DIS instructions when installing the adapter and using it to carry out
measurements. The adapter is fitted with an electronic fuse which cuts out if the current
should exceed approx. 4 Amp to prevent its getting damaged.
Calling up the DIS voltage and current supply test plan:
E38, E39 and future model series under function selection
Drive -> Engine -> Alternator
o r
Body -> Body electrics -> General electrical system -> Voltage and power supply
o r
Components -> Component information -> Alternator power supply -> Power supply
Older series
Power supply
Procedure:
Store tools are intended for repair shops and are only supplied to order.
(Please refer to Enclosure 1)
SWS Adapter for measuring stall current All model series
BMW AG - TIS
23.01.2013 12:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
